 | This article has multiple issues. Please help improve it or discuss these issues on the talk page. (Learn how and when to remove these messages)
|
Allowable Strength Design and Allowable Stress Design (ASD) are terms used by the American Institute of Steel Construction (AISC) in the 14th Edition of the Manual of Steel Construction.[1][2]
Allowable Stress Design philosophy was left unsupported by AISC after the 9th edition of the manual which remained an acceptable reference design standard in evolving building codes (e.g. International Building Code by the International Code Council). This presented problems since new research, engineering concepts and design philosophy were ignored in the minimum requirements and references in the aging 9th edition. As a result, structures that were code compliant based on design using the Allowable Stress Design methods may not have been code compliant if reviewed with the Load and Resistance Factor Design (LRFD) requirements - particularly where the LRFD procedures explicitly defined additional analysis which was not explicitly defined in the Allowable Stress Design procedures.
AISC's Allowable Strength Design applies a quasi-safety factor approach to evaluating allowable strength. Ultimate strength of an element or member is determined in the same manner regardless of the load combination method considered (e.g. ASD or LRFD). Design load combination effects are determined in a manner appropriate to the intended form of the analysis results. ASD load combinations are compared to the ultimate strength reduced by a factor (omega) which provides a mathematical form similar to Allowable Stress Design resolved with a safety factor.
This AISC Allowable Strength Design does not attempt to relate capacity to elastic stress levels. Therefore, it is inappropriate to refer to the procedure or philosophy as either Allowable Stress or Permissible Stress Design.
See also
References
- ↑ Duncan, Cynthia; Fenves, Steven; Iwankiw, Nestor (2006). "Technical Note: Determination of Allowable Strength Design Safety Factors in the 2005 AISC Specification" (PDF). aisc.org. American Institute of Steel Construction. Archived (PDF) from the original on 14 January 2025. Retrieved 14 January 2025.
- ↑ "Specification for Structural Steel Buildings – Allowable Stress Design and Plastic Design" (PDF). aisc.org. American Institute of Steel Construction. 1 June 1989. Archived (PDF) from the original on 14 January 2025. Retrieved 14 January 2025.
 | This engineering-related article is a stub. You can help Wikipedia by adding missing information. |